Skip to content

MPI Probe Station Integration

The source material for MPI probe station integration is limited — it is primarily a diagram/photo deck (TSRI mounting hardware options and photos of a Microsanj Thermal Chuck mounted on an MPI probe station) with very little extractable text. [the source deck is primarily diagrams/photos of mounting hardware — see original file for visuals]

What the source text does confirm:

  • TSRI mounting options for the thermal chuck-to-probe-station interface:
  • Option 1 — approximately 45 mm height, with a circular bottom plate for vacuum mounting.
  • Option 2 — approximately 45 mm height, screws into the MPI plate.
  • Option 3 — 80 mm height, providing full tip/tilt with MPI chuck removal.
  • A 3D-printed cover is referenced alongside these mounting options.
  • MPI mount with Olympus — an illuminator on this mount can rotate 90 degrees.
  • The Microsanj Thermal Chuck is shown mounted to an MPI probe station.
  • Mounting hardware reference: TSRI TS200.

[diagram/image in source — not reproduced here: photos of the three TSRI mounting options, the 3D-printed cover, the MPI mount with Olympus illuminator, and the Microsanj Thermal Chuck mounted on the MPI probe station]

For dimensional drawings and mounting hardware photos, refer to the original source deck.